mATX Minimal Case sutible for smaller printers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a sturdy and strong but open case broken into pieces to be able to be printed on most 3d Printers
- Ocena
- 5 / 5
- Polubienia
- 82
- Pobrania
- 327
- Wydruki
- 5
- Wyświetlenia
- 3374
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
This case was designed to lock together well while requiring minimal filament and able to be printed on most printers. I printed this on my ender 3 (Stretched to the limit in someplaces) and is setup to acomodate a Dual slot gpu, though no taller than the slot. I used 13mm M3 screws and heat set threaded inserts to asemble the case together. It accomodates my atx power supply quite tightly and you may need to modify it a bit to suit your need. The cross brace on the bottom also raises the case to allow power to the PSU. I think it looks great in the two tone and is about as compact as I could make it without additional parts like pcie riser cable to special psu's. There's no mount for a power button or front panel I/O cause I dont need them. The PC Stays on all the time and I have enough ports on the back. But I did consider replaceing one of the top brackets with a large one that could hold any I/O. I think that's a easy place to modify it if you want.
Update 28/06/2024:
I have added step files for parts for customizing