Swirl Toothbrush and Toothpaste Holder with Inserts and Drainage

Swirl pattern holder for two manual or electric toothbrushes and toothpaste - up to 28mm (1.1") toothbrush shaft diameter.

Update December 22, 2024:

Added Toothpaste Tube Insert to allow neat storage of your toothpaste with the cap up!  This new insert can be used in any of my toothbrush holder designs that support inserts...

Toothbrush and Toothpaste Holder with Drainage https://www.printables.com/model/618988-toothbrush-and-toothpaste-holder-with-drainage

Double Toothbrush and Toothpaste Holder with Inserts and Drainage https://www.printables.com/model/621767-double-toothbrush-and-toothpaste-holder-with-inser

Swirl Toothbrush and Toothpaste Holder with Inserts and Drainage https://www.printables.com/model/715554-swirl-toothbrush-and-toothpaste-holder-with-insert

See newly added photos.  The Toothpaste Tube Insert can be printed in PETG or PLA and doesn't require supports or any special slicer settings.

--------

Features a concealed, ventilated drainage system.  With other holders that have no drainage, your toothbrushes are constantly sitting in dirty water that is a breeding-ground for bacteria - yuck!  When other holders do have drainage, they usually drain right onto the countertop - making a big, wet mess.

This design allows water that remains on your toothbrushes when you finish brushing to drain into a separate compartment below your toothbrushes and toothpaste - where it can slowly evaporate through the 20 drain/ventilation openings!

Optional Inserts of various sizes allow smaller toothbrushes to be held upright and can be printed in different colors to personalize each toothbrush slot.  The provided inserts hold toothbrushes up to 16, 20, or 26mm in diameter, and another one holds up to 10 by 15mm (rectangular shaft) toothbrushes.

The provided STL files are intended to be printed in PETG and do not require supports.

PrusaSlicer 3MF files are provided for generic PETG, and G-code files are provided for the Original Prusa MK4.

The Swirl Toothbrush and Toothpaste Holder seen in the photos was printed on an Original Prusa MK4 with Sunlu Transparent Blue PETG with a 0.4mm nozzle using Input Shaper at 0.2mm SPEED layer height with 5% Gyroid infill and a Monotonic Lines top fill pattern.

The Inserts seen in the photos were printed on an Original Prusa MK4 with various colors and brands of PETG with a 0.4mm nozzle at 0.3mm DRAFT layer height with 5% Gyroid infill and a Concentric bottom fill pattern.  Note that the printed bottom is actually the top when placed in the holder.  The 26mm insert may need a brim if your printer doesn't have very good adhesion and leveling; my Original Prusa MK4 with a Textured PEI Sheet didn't need a brim.

Note that the Inserts in this design also work with ALL my toothbrush holder designs that support inserts!

Be sure to check out my other designs - including honeycomb storage wall (HSW) accessories, universal key covers, and a diverse collection of household accessories and 3D printing tools - on Printables at https://www.printables.com/@PhilCaruso/models