1 / 4
HC Diana - Folding Battery Door with Latch (5mm extension) — zdjęcie 1
1 / 4

HC Diana - Folding Battery Door with Latch (5mm extension)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Uses the existing M2 screw the Diana comes with, allows tool-less access to the lipo battery.

Ocena
0 / 5
Polubienia
34
Pobrania
243
Wydruki
1
Wyświetlenia
1169
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Materials List
- x1 3M x 12mm screw
- x1 10mm compression spring (length can be shorter if you have a stronger/stiffer spring)
- 8-9mm of Wire Hanger or other metal rod < 3mm in diameter
- x1 2M x 3mm screw (should be included with the HC Diana)

Instructions
 - Take your metal wire hanger rod, test its fit into the holes shared between the Battery Cover and the Cover Base. If the fit is loose, take pliers and bend about 1-2mm of edges slightly, to better hold the rod in place. The Battery Cover should pivot easily around the cover base. 

- Place the Battery Cover face down, and make sure the cup on the inside is clear of burrs. Compress the spring into the cup, and insert the Latch. The spring should fit into the circle slot in the bottom of the latch. Screw the 3M screw through the cup and the latch. The latch should move up and down with no resistance except the spring (some trimming may be needed). See photos for reference.

- Once the latch part is seated correctly, screw 2M screw into the Cover Base and the bottom of the Diana. It might rotate while you tighten the screw, so make sure you hold the cover base straight while you tighten.

Other
- This door is not flush like the default battery door, it sticks out around 5mm. The inside space is around 3-4mm, but only on the lower part of the battery cover, due to the latch screw taking up the upper half. Keep that in mind when orienting the battery, you'll want the lipo wires to be on the bottom of the battery holder, so they can actually use the battery cover's extra space.
- Two latches are included, one that is flush with the Battery Cover, and the other that sticks out around 3mm so it's easier to use the latch. The latch in the reference photos is the flush latch.

Tagi