RepRack 2020 Extrusion Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
2 x 18mm M5 bolt and 2 x M5 hammer nut and you're good to go (per mount).
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 552
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
Mount your RepRack to 2020 extrusion troughs with this cleat. For each cleat, you need 2 M5x18 bolt and 2 M5 hammer nuts. If tapping and threading the extrusion, you'll likely need longer bolts.
I've found a little bit of warping is actually a good thing for this model. The mount applies a constant force on the bolt, eliminating the need for lock washers.
There are also some 3.5mm holes near the top of the model. I originally was going to add some more support to the mount, but it wasn't necessary. I left the holes in the model because "why not?".
BOM (per mount):
2 x M5x18 bolt
2 x M5 Hammer Nut