RepRack 2020 Extrusion Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
2 x 18mm M5 bolt and 2 x M5 hammer nut and you're good to go (per mount).
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 41
- Makes
- 0
- Views
- 552
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Share Alike
Mount your RepRack to 2020 extrusion troughs with this cleat. For each cleat, you need 2 M5x18 bolt and 2 M5 hammer nuts. If tapping and threading the extrusion, you'll likely need longer bolts.
I've found a little bit of warping is actually a good thing for this model. The mount applies a constant force on the bolt, eliminating the need for lock washers.
There are also some 3.5mm holes near the top of the model. I originally was going to add some more support to the mount, but it wasn't necessary. I left the holes in the model because "why not?".
BOM (per mount):
2 x M5x18 bolt
2 x M5 Hammer Nut