SV06 Monoblock Extruder + Custom Fans

With the exception of the holes for the set screw on the lower bearing, I kept all the original proportions of the original block.

You probably only need to enable the supports in the bearing and shaft insertion holes.

I added a version with the belt guide closed [BGC]. It increases the stability, rigidity and ease of printing of the part, but makes installation difficult, making it necessary to cross the hole with the belt. If you prefer, you can use the version with the open belt guide [OBG], the structure of the part should not be greatly affected by this.
 

• V1.01 - I inserted a model to cover the belt if you don't use a custom fan.
• V1.1 - Some improvements in the tolerance of holes and fittings.

THIS IS A BETA MODEL AND UNTESTED. 

Unfortunately, my printer burned out one of its TMC drivers, and even though I have already ordered others, I can't test this model until they arrive. But I believe it is already fully functional.

I thought about creating a model that uses the four holes in the corners, but this could reduce the efficiency of the distribution of the bearings (which in the Monoblock are further apart for better stability). And as this fan model is not one of the most popular, I only kept the rear holes of the most used ones. If you want, I can make a model that has these holes. 

The fan model in the 3d render is the "SOVOL SV06 FAN DUCT 5015 - CFD OPTIMIZED VERSION 2.0" by Designer TAEKY. (It needs to be slightly modified to fit perfectly, but as it is a model that does not allow REMIX, I will not publish it.)