Kegerator Pressure Regulator Dial w/Hole
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The original regulator dial by rubisco2000 was great, except that my regulator's screw turns with quite a bit more…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 86
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
(Imported from my models on Thingiverse: https://www.thingiverse.com/muchtall/designs )
The original regulator dial by rubisco2000 was great, except that my regulator's screw turns with quite a bit more resistance than most, apparently. As a result, the plastic rail that the flat-head screw slides into wasn't strong enough to hold the screw, even with the lock nut tightened into place. Therefore I needed a version of this with a hole in the face to allow me to tighten the screw down against the nut more securely.
A couple other, minor adjustments to this model:
- Reduced the size of the insertion holes to match the width of the screw head slide channel
- Removed the flat-head slot rail since it's no longer of any value
The modified SCAD document is also attached.
Print Settings
Printer Brand:
Creality
Printer:
CR-10S
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
20%
Filament: AmazonBasics PETG Blue
Notes:
Printed with tree supports in Cura, but might work fine without.
Category: Kitchen & Dining