Kegerator Pressure Regulator Dial w/Hole
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The original regulator dial by rubisco2000 was great, except that my regulator's screw turns with quite a bit more…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 14
- Makes
- 0
- Views
- 86
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution
(Imported from my models on Thingiverse: https://www.thingiverse.com/muchtall/designs )
The original regulator dial by rubisco2000 was great, except that my regulator's screw turns with quite a bit more resistance than most, apparently. As a result, the plastic rail that the flat-head screw slides into wasn't strong enough to hold the screw, even with the lock nut tightened into place. Therefore I needed a version of this with a hole in the face to allow me to tighten the screw down against the nut more securely.
A couple other, minor adjustments to this model:
- Reduced the size of the insertion holes to match the width of the screw head slide channel
- Removed the flat-head slot rail since it's no longer of any value
The modified SCAD document is also attached.
Print Settings
Printer Brand:
Creality
Printer:
CR-10S
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
20%
Filament: AmazonBasics PETG Blue
Notes:
Printed with tree supports in Cura, but might work fine without.
Category: Kitchen & Dining