1 / 2
Spacer for WhamBam Magnetic Build Plate on Anycubic Photon Mono M5 — zdjęcie 1
1 / 2

Spacer for WhamBam Magnetic Build Plate on Anycubic Photon Mono M5

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Spacers for magnetic build plate on a Photon M5

Ocena
0 / 5
Polubienia
2
Pobrania
82
Wydruki
0
Wyświetlenia
566
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

I wanted to get a magnetic build plate for my Photon Mono M5, but WhamBam only had it for the M5S. After a bit of research, and determining that the build plates are the same size, I decided to give it a try, and it seems to work perfectly with this little adapter.

These spacers replace the metal cylinder spacers on the build platform. I've designed them to be 2.6mm shorter than the stocker spacers, and otherwise identical. This should match the width of the whambamsystem, allowing you to use the M5S magnetic build plate on an M5

Originally printed in ABS Like +(pictured in white) for prototyping and testing, and reprinted in SirayaTech Blu Nylon Like Black for more permanent installation.

Note: You will also need to shorten the two screws, or buy shorter screws. I just cut a few mm off with the dremel and it seems to work fine!

2 needed per build platform, but offering the models as single or double. I just printed them upright with no raft or supports

V2 just widened the hole so the bolt doesn't bind during installation

Tagi