Coolermaster MM720 Mouse Wheel - v2 (hollow version)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Closer to stock MM720 mouse wheel (because mine broke off the "tip", the crank that fits the encoder).
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 238
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
“Realistic” version of MM720 mouse wheel (because mine broke off the "tip", the crank that fits the encoder).
V2 is hollowed out, with thin “fins” located on the edge of one of the sides, connecting to the center. This is closer to the original wheel, and as such allows for the LED to be placed on the correct spot :)
Printed in two parts for cleaner print. Use supports for the wheel. Make sure to orient them on the base (wheel flat with thins on the top, rod vertical). Use 0.18mm or lower to keep fidelity (important for end tip on rod and middle gap on wheel).
Joined together by “force”. If print is accurate enough, let material cool off, remove wheel supports and apply some force on the wheel on a flat hard surface, pushing down against the rod. Wheel should be positioned around the middle of the thicker rod part (so it stays on the middle of the mouse). Use .blend and screenshots for reference.
Used the original rubber cover on it, works great!
Printed on standard PLA.