Orbi (RBK13) WiFi access point wall mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a wall mount for the "boxy" Orbi WiFi access points. There are tons of designs for the other models, but not…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 144
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution
This is a wall mount for the "boxy" Orbi WiFi access points. There are tons of designs for the other models, but not for this one. Since nothing existed, I made it. The bottom and sides are open so that cooling should be unaffected.
I recommend using adaptive layers so that the small overhang at the top comes out cleanly, while allowing the bottom 95% to print quickly. It will print fine without support, but needs smaller layers to prevent stringing. I used a standard layer height of .20 with adaptive +/- of .04 which should give a .16 layer for the overhang.
My prints were on an Ender 3 V2 using eSun filament.
Print Settings
Rafts: No
Supports: No
Resolution: .20
Infill: 20%