Orbi (RBK13) WiFi access point wall mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a wall mount for the "boxy" Orbi WiFi access points. There are tons of designs for the other models, but not…
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 41
- Makes
- 0
- Views
- 144
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution
This is a wall mount for the "boxy" Orbi WiFi access points. There are tons of designs for the other models, but not for this one. Since nothing existed, I made it. The bottom and sides are open so that cooling should be unaffected.
I recommend using adaptive layers so that the small overhang at the top comes out cleanly, while allowing the bottom 95% to print quickly. It will print fine without support, but needs smaller layers to prevent stringing. I used a standard layer height of .20 with adaptive +/- of .04 which should give a .16 layer for the overhang.
My prints were on an Ender 3 V2 using eSun filament.
Print Settings
Rafts: No
Supports: No
Resolution: .20
Infill: 20%