Hitec Servo Horn for T3
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Revised to replace stock servo horn for the Team Associated T3. 15.5mm center to center.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 64
- Wydruki
- 0
- Wyświetlenia
- 214
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
Revised to replace stock servo horn for the Team Associated T3. This should work for other applications. The length center to center is 15.5mm. There are two versions one without added bracing and one with. These are fairly stout so both are quite stiff. I printed these without supports and other than a little loose extrusion in the screw countersink there were no issues. You may want to use a brim for adhesion since these are small parts. The hole for the ball-stud will likely need to be reamed a bit to start threads. I ran a tap through and everything fit up fine.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
200
Infill:
20
Filament: Polaroid PLA Silver
Category: R/C Vehicles