1 / 4
Tool belt hammer holder with magnet, and quicksquare holder.
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tested and now seems to work good.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 90
- Wydruki
- 0
- Wyświetlenia
- 740
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (14)Powiązane
So, I did not find any good hammer holders out there - neither commercial nor DIY. But, Prusa to the rescue. And the quicksquare as well! Very useful while renovating my garage.
The hammer is fastened with a magnet - I use a 50mm by 20mm by 10mm neodymium. Sticks well.
The quicksquare is fastened with a twist hook.
Clips over pockets - back or front - possibly also on the belt, but I prefer them a bit lower.
Printed in PETG 0.3mm layers + 10° for better layer adhesion.