RAK19007 Rugged WisBlock Enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
RAK19007 Rugged WisBlock Enclosure - A rugged outdoor enclosure for the RAK19007 WisBlock base board.
- Ocena
- 4 / 5
- Polubienia
- 78
- Pobrania
- 418
- Wydruki
- 2
- Wyświetlenia
- 6605
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial
RWE (Rugged WisBlock Enclosure) is a remix of the open-source ruggedized T-Beam enclosure, now for the RAK19007 WisBlock base board with RAK4631 (LoRa) and RAK12500/1910 (GNSS/GPS) modules.
This induces a couple important build and electrical component changes which include:
- RAK19007 WisBlock Base
- RAK4631 WisBlock Core
- RAK12500 WisBlock GNSS Module (if GPS desired)
- RAK1921 OLED Display (if screen desired)
- Serial node access knowledge would be recommended if you are choosing to go without a screen.
- SMA Female to IPX Pigtail - 10~ish cm
- 1x- 12mm LATCHING stainless steel waterproof push button
- This time you will wire in series with the battery positive for physical power disconnect.
- Also, JST battery receptacle on the board will need desoldered and wires with the XT-30 and switch in series soldered onto the pads. Please be very careful, these pads are close together and sloppy soldering could result in a short circuit. It was taller than I wanted it, and I wanted my case to be as slim as possible. I will hopefully release a much thicker front cover in the future for those who do not want to do this and utilize the JST instead.
- 1x- Waterproof panel mount USB-C
- 1x- USB-C male breakout
***WARNING***
THIS BUILD IS NOT FOR BEGINNERS OR THE FAINT OF HEART. YOU MUST BE PROFICIENT WITH A SOLDERING IRON. I HAVE PROVIDED LITTLE BUILD GUIDENCE, YOU MUST KNOW WHAT YOU ARE DOING. IMPROPER CONSTRUCTION COULD RESULT IN DAMAGE TO YOUR WISBLOCK, FIRE, OR INJURY TO YOURSELF.
***
I hope to provide a more detailed build guide in the future, but I wanted to get the open-source project out into world. In hopes of getting folks building and contributing to the project if they are interested.
Lastly, I will list one full build for sale on my Etsy. I will also list case prints or additional full builds if demand exists. Let me know if this interests you via comments or DMs and I am happy to exercise accommodations.
https://www.etsy.com/shop/Print3DbyKorbyn?ref=profile_header