MagSafe wall mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
If you have en Iphone and a MagSafe charger, use this model to mount your phone on any surface.
- Ocena
- 3,6 / 5
- Polubienia
- 96
- Pobrania
- 569
- Wydruki
- 3
- Wyświetlenia
- 3489
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Wall-mounted
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
!If you want to use your MagSafe charger as a mount for your Iphone, this is a simple and elegant solution.
Only 2 pieces, 1 mounted to the surface, and the other slides over yours MagSafe and clics into place. Your can easily remove the MagSafe from the mount by just sliding the outer piece.
Printing
The 2 STL are already oriented for optimal printing.
Layer height : I recommend 0.2mm
Infill : 15% or more
Mounting
Mounting the base : I made 4 holes for flathead M3 screws but it can easily be mounted with glue or double sided tape.
The MagSafe is then placed in the center with the cord passing through the slot.
The “slider” piece is then placed over the base by sliding it down. The slider locks into place, no glue or screw needed.

Enjoy !