Bosch GWS 12V-76 guard
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Optimized hand guard for Bosch 12V electric angle grinder
- Ocena
- 0 / 5
- Polubienia
- 30
- Pobrania
- 118
- Wydruki
- 0
- Wyświetlenia
- 1247
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a 3D-Printed Guard for the Bosch GWS 12V angle grinder. It is much more useful with a smaller guard like this so I designed one (never use without the guard - you don't want to get your little hands caught in there..)
You have to use a very high performing material to get a useful and safe part. Disclaimer: I printed two of them to stress- test it. I would suggest for you to do the same and after properly printing + annealing the part try destroying it yourself :)
Pro-tip: Use metal cutting discs with carbide or diamond grain - they will not shatter.
Preferably use PA6-CF but most importantly from a reputable Brand (3dxtech, Essentium, Spectrum, AddNorth, Polymaker, Prusament etc.)
If you have no enclosure for your printer, try PET-CF. Same principles apply ⬇
0.6mm nozzle
max. volumetric Speed ~ 5mm3/s
Nozzle cranked to the max. eg 300°C (look at the TDS from Manufacturer)
Bed ~80-110°C
No cooling and no Fans active!!
Let the chamber heat up to 50°C before starting, if you have an enclosed Printer that is.
After printing let the part cool down a bit, remove and anneal in 70°C water for 15min (not longer). Afterwards let dry overnight.