Multiboard alternative mount (WIP)- Tape measure holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
WIP - working on an alternative multiboard mount option that is strong and easy to print with no supports.
- Ocena
- 4,333 / 5
- Polubienia
- 31
- Pobrania
- 227
- Wydruki
- 2
- Wyświetlenia
- 1617
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution — Noncommercial
Strongly inspired by the mounting system developed by KYZ Designs for the Honeycomb storage wall.
I found trying to figure out which mount would be best for remixing hard, and loved the KYZ options for my HSW stuff, so figured I'd try to do the same for the multiboard.
Basically the mount should just press right in. But it might come out if too much down or side force is applied. So add the locking pin to hold it in there tight. At least with my print settings it is held in super tight, but might differ depending on your tolerances.
As an initial test I have made a tape measure holder (it's one of the first things in the HSW tiles i'm replacing with multiboard. But I will add more if this works better than the remix option that multiboard are putting out ‘soon’.