1 / 2
Remix of Semi-Flex Clasp for Spannerhands' filament box — zdjęcie 1
1 / 2

Remix of Semi-Flex Clasp for Spannerhands' filament box

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Semi-Flex Clasp Remix with PETG

Ocena
0 / 5
Polubienia
1
Pobrania
19
Wydruki
0
Wyświetlenia
169
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Share Alike

The Semi Flex Clasp did not work out for me when I printed it with 95A TPU; even at 100% infill. Just seemed to flex too much when closed allowing the lid to lift slightly. In addition, I did not want to get 98A TPU and I wanted to use a more common material.

I remixed the original clasp to allow non-compliant materials for use. My remix changed the top wrap around clamp to simply slip on. Now the clasp can be printed with hard materials like PLA or PETG.

I then print my design with no top or bottom shells, 1 perimeter shell, and Aligned infill in the 15-25% range. With no top or bottom shells the non-compliant material is flexible enough to stretch and hold the lid tight.

I suggest PETG as it is more flexible than PLA but this clasp uses very little material, about 6 - 10 grams depending on infill %, so please experiment! So far 1 perimeter has worked well. More perimeters will increase stiffness and durability. 

Tagi