Nerf Rival Pathfinder XXII-1200 Pump Grip with Picatinny Rail
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adds picatinny rails to underbarrel pump for custom foregrips.
- Ocena
- 5 / 5
- Polubienia
- 35
- Pobrania
- 163
- Wydruki
- 2
- Wyświetlenia
- 1401
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial
This pump grip replaces the original so that custom foregrips can be attached.
It's still comfortable to use even without a foregrip installed.
Images depict the pump grip with the angled foregrip below:
https://www.printables.com/model/235802-angled-mini-foregrip
PRINTING:
- Recommended to print with PETG for impact resistance.
- Does not require supports if printed as oriented in file.
- Requires good bed adhesion - consider adding a brim.
- Requires decent bridge quality
- Only at one spot near very beginning of print.
INSTALLATION:
- Locate and remove all 6 screws attaching pump
- Remove the pump
- Locate orientation arrow on inside wall of 3D printed pump grip
- Arrow points towards nozzle, away from shoulder stock.
- Snap new grip into place with arrow facing nozzle.
- Replace the 4 screws that attach to the slider.
- Finished - save the 2 unused screws as backups and print off a new foregrip!
TROUBLESHOOTING:
If after installing the new part the pump gets stuck half way (i.e. wont fully retract or extend) you may need to remove a plastic stopper from inside the shell. This part can get easily dislodged or break when messing with the pump. It can be best to just remove the part entirely.
- Lay blaster on a flat surface
- Remove all screws holding shell together.
- Remove the top shell half.
- locate the little black spring loaded wedge piece (see images)
- Remove entirely.
- Replace shell and screw.
Please visit our Etsy shop to see what else we do!
https://kettlefishcreations.etsy.com