Land Rover 332215 B/C-Pillar Rubber Corner
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The B/C-pillar rubber corners often deteriorate and replacements can be quite expensive. So you can print your own 🥳
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 30
- Wydruki
- 0
- Wyświetlenia
- 218
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
General
This is a replacement for the rubber corner for the Land Rover Series and early Defender B- and C-Pillar (part number 33215). Commercial replacements are available but as you need 4 or 6 for each vehicle, printing can be cheaper.
The original rubber is very soft, so I recommend you to get the softest TPU available to you and printable on your printer.
Versions
“Neutral” - Both sides are equal like the original part. You can print the same parts for all corners.
“Corner Specific” - These models are skewed to the angle of the side walls, resulting in a nicer fit. But they are not universal anymore and you have to print all four for the four corners.
Print Settings
- Use TPU or other flexible filament (as soft as possible)
- Infill depending on TPU hardness, 90-100% is probably desireable to avoid too much “squishing”
Special thanks to https://www.printables.com/@CasperMeyhoff_710172 for providing measurements and photos for replicating this part 👍
Please consider liking and posting a make if you find this useful 🙂