Bambulab A1 bed cable holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
this cable holder clips into the base of the heated bed cable and prevents it from rubbing against the wall
- Ocena
- 5 / 5
- Polubienia
- 85
- Pobrania
- 491
- Wydruki
- 2
- Wyświetlenia
- 3084
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
My Bambulab A1 sits quite close to the wall since my table is not the longest, this cable holder is meant to clip into the base of the heated bed cable and give it a curve so that it doesn't rub against the wall quite as much.
To insert it into the cable start with the wide section, slide it on near the base of the cable and push it towards the printer until it's completely inserted inside the wider part, then push the rest of the cable inside with a bit of force (while testing i inserted and removed it many times and my cable is still fine so don't worry about damaging it), finally moving the bed forward and backwards a few times should make it automatically find its angle (like in the video)