Pifinder Bottom / Mount to Hadley
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement for the PiFinder Case V2 Bottom that will attach to the 1/2 inch Rods of a Hadley telescope.
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 23
- Wydruki
- 1
- Wyświetlenia
- 416
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a merge of two parts, the part “Bottom” of BBLab's PiFinder, and the part “Test_Print” from Maff's Hadley Telescope. Print time on this part is just a bit longer than BBLab's Bottom. It will eliminate the need to print the dovetail mounting hardware and figure out how to get a dovetail on your Hadley, AND reduce the need for four heat stake inserts and related cap screws.
BBLabs noted that folks might need a left or right hand version. If this is oriented wrong for your configuration you can fix it in your slicer by doing a Mirror around the X Axis.