Carriage for Flyingbear Ghost E3D V6 40mm fan MK2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix for the Ol' FB ghost
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 52
- Wydruki
- 0
- Wyświetlenia
- 432
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I tried to print an old carriage found online but i see that's there are a lot of Issue for printing it.
So i decided to remix myself and convert it to a "Printer Friendly Model" with some improvement.
For mounting it you will need only some M3 screws and nut
Update MK2
Detachable belt fixer plate for an even better printing.
Improvement:
40mm fan mount
dual piece main carriage, easy to print.
improved fan shroud
You will need:
Carriage V2 x1
Hot end mount x1
Hotend block x1
tensioner plate x1
Cover x1
Blower Duct V2 x2
NOTE: Main carriage is the older version where The tensioner plate and the carriage are not splitted, i don't use this for his difficulty to achieve good results without support material.
Print Settings
Printer:
Cargobot MK3
Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Resolution:
0.2
Infill:
30%
Filament:
Red gloss
Notes:
Use PETG for better mechanical stress.
Tested with PLA+ and PETG but the last one was better.
Print them sided