Carriage for Flyingbear Ghost E3D V6 40mm fan MK2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix for the Ol' FB ghost
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 52
- Makes
- 0
- Views
- 432
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I tried to print an old carriage found online but i see that's there are a lot of Issue for printing it.
So i decided to remix myself and convert it to a "Printer Friendly Model" with some improvement.
For mounting it you will need only some M3 screws and nut
Update MK2
Detachable belt fixer plate for an even better printing.
Improvement:
40mm fan mount
dual piece main carriage, easy to print.
improved fan shroud
You will need:
Carriage V2 x1
Hot end mount x1
Hotend block x1
tensioner plate x1
Cover x1
Blower Duct V2 x2
NOTE: Main carriage is the older version where The tensioner plate and the carriage are not splitted, i don't use this for his difficulty to achieve good results without support material.
Print Settings
Printer:
Cargobot MK3
Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Resolution:
0.2
Infill:
30%
Filament:
Red gloss
Notes:
Use PETG for better mechanical stress.
Tested with PLA+ and PETG but the last one was better.
Print them sided