Ring Spotlight Cam Plus Rain Hood
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple hood for the Ring Spotlight Cam Plus.
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 66
- Wydruki
- 1
- Wyświetlenia
- 588
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
I heard that rain will run onto the lens of an outdoor-mounted Ring Spotlight camera, so I wanted to add a small cap that would prevent rain from running directly onto the front of the camera. I printed it at 100% and it was a snug fit, but I did throw a couple small pieces of VHB to make sure it doesn't fly off in a windstorm.
You can see in my photos that I hit it with a layer of spraypaint afterwards (just the top) to add an additional layer of protection… and to make it match the camera.
I added a spot on the top to make sure the setup button doesn't get pressed while it's on. As such, print it upside down (like in the STL) so you don't need supports.