Office Chair Chock for Sim Racing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wheel chock designed to fit standard 50mm office chair wheels.
- Ocena
- 5 / 5
- Polubienia
- 141
- Pobrania
- 841
- Wydruki
- 10
- Wyświetlenia
- 2541
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial
I designed these wheel chocks after trying to use racing sims with a wheeled office chair, this proved problematic as the chair would move when putting pressure on the pedals.
I designed these chocks to fit standard 50mm wheels. They use a centre “divider” in order that the wheel does not slip off during use. These chocks work well however can be improved by gluing rubber/foam to the bottom, I personally used some cut-offs from an old bike inner tube which works very well.
After printing these chocks I no longer had the problem of the chair slipping around.
You could print one chock for every wheel however this is unnecessary and 2 will suffice.
It is important that the infill is at least 50%, this is to give it the strength needed.