Roost Cafe Coasters - Animal Crossing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Coasters featuring Brewster's logo from Animal Crossing Roost Cafe. Multicolor via Z hop or single color embossed.
- Ocena
- 0 / 5
- Polubienia
- 40
- Pobrania
- 73
- Wydruki
- 0
- Wyświetlenia
- 652
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A coaster set featuring Brewster's logo from Animal Crossing Roost Cafe. The embossed version is one file and straight forward to print. The multicolor version is designed to print with Z Hop enabled. If you want to slice your own multicolor, here are the steps:
1. Set Cura to your filament color for the cup (red), a layer height of 0.2 mm, and skirt turned off
2. Load the cup, brewster, and coaster models
3. Select all models
4. Edit > Merge models (this will snap them into the correct orientation)
5. Move the merged models somewhere where they will not interrupt your bed-leveling or homing routine
6. Unmerge models
7. Delete the brewster and coaster models, slice cup as normal.
8. CTRL+Z to get the other two models back, and set your Z-hop height to 0.4 mm or higher
9. Delete the cup and the coaster models, set your filament color to brewster (green), slice brewster with the Z-hop enabled
10. CTRL+Z to get the other two models back, delete the cup and brewster, set your filament color to the coaster (white) and slice with Z-hop still enabled
11. Print the cup gcode, immediately followed by the brewster gcode, immediately followed by the coaster gcode.
If you want to use my pre-sliced gcode, please note it was sliced for an Ender 3 V2 with UBL 3 point tilt enabled.