Roost Cafe Coasters - Animal Crossing
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Coasters featuring Brewster's logo from Animal Crossing Roost Cafe. Multicolor via Z hop or single color embossed.
- Rating
- 0 / 5
- Likes
- 40
- Downloads
- 73
- Makes
- 0
- Views
- 652
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A coaster set featuring Brewster's logo from Animal Crossing Roost Cafe. The embossed version is one file and straight forward to print. The multicolor version is designed to print with Z Hop enabled. If you want to slice your own multicolor, here are the steps:
1. Set Cura to your filament color for the cup (red), a layer height of 0.2 mm, and skirt turned off
2. Load the cup, brewster, and coaster models
3. Select all models
4. Edit > Merge models (this will snap them into the correct orientation)
5. Move the merged models somewhere where they will not interrupt your bed-leveling or homing routine
6. Unmerge models
7. Delete the brewster and coaster models, slice cup as normal.
8. CTRL+Z to get the other two models back, and set your Z-hop height to 0.4 mm or higher
9. Delete the cup and the coaster models, set your filament color to brewster (green), slice brewster with the Z-hop enabled
10. CTRL+Z to get the other two models back, delete the cup and brewster, set your filament color to the coaster (white) and slice with Z-hop still enabled
11. Print the cup gcode, immediately followed by the brewster gcode, immediately followed by the coaster gcode.
If you want to use my pre-sliced gcode, please note it was sliced for an Ender 3 V2 with UBL 3 point tilt enabled.