Stepped Screwdriver bit holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Storage and organisation solution for my 48 LTT screwdriver bits, plus some extra space. Works with any 1/4" hex bit
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 211
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
Wanted to make a bit holding system that didn't use magnets, but held ¼" bits snugly but not too tight. The little cantilevers should help account for normal tolerances in the hex sizes while still holding them kind of snug
you'll have to enable support for the drawer insides, but I've sized the drawers generously smaller so hopefully no sanding should be required.
I added these 2mm x 4mm magnets to make the drawer closures feel nicer (I populated only two sets, but if you like a stronger hold, there's more holes)