Eureka Mignon Grinder Split Hopper (For two types)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Designed a hopper to fit two different beans so I could have normal and decaf.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 73
- Wydruki
- 0
- Wyświetlenia
- 872
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
To allow for normal and decaf beans I created a hoppper based on the original that comes with the Eureka Mignon ORO XL.
Instead I put a wall between the middle and some tabs to control the flow of beans from each section.
Note: it may fit the other Eureka grinders but not tested it as I only have the one. Would love to know if the sizings are same (which I assume they are)
V2 (In progress)
The current design, the space between the “tabs” and the space for the grinder fits about 14g of beans in it.
I'm designing a new version to add a little more space below so that I can made one “full” shot around 17-18g. This allows you to open and close each tap and act as a very basic dose.
Print Settings
- .20
- Material - PETG or PLA ( I choose PETG because of the food safety)
- 15% Gyroid Infill - you could lower or higher this depending on how sturdy you want it.
- Support on
- Build plate only
- Tree - Slim
BambuStudio Settings
When printing in Bambu Studio I had some layer adhesion issues with the curved wall because of the overhangs. These settings help minimised it for me.
- Slow down on overhangs should be off
- Using Genetic PETG slow down the max volumetric flow to 10mm/s