Eureka Mignon Grinder Split Hopper (For two types)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Designed a hopper to fit two different beans so I could have normal and decaf.
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 73
- Makes
- 0
- Views
- 872
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
To allow for normal and decaf beans I created a hoppper based on the original that comes with the Eureka Mignon ORO XL.
Instead I put a wall between the middle and some tabs to control the flow of beans from each section.
Note: it may fit the other Eureka grinders but not tested it as I only have the one. Would love to know if the sizings are same (which I assume they are)
V2 (In progress)
The current design, the space between the “tabs” and the space for the grinder fits about 14g of beans in it.
I'm designing a new version to add a little more space below so that I can made one “full” shot around 17-18g. This allows you to open and close each tap and act as a very basic dose.
Print Settings
- .20
- Material - PETG or PLA ( I choose PETG because of the food safety)
- 15% Gyroid Infill - you could lower or higher this depending on how sturdy you want it.
- Support on
- Build plate only
- Tree - Slim
BambuStudio Settings
When printing in Bambu Studio I had some layer adhesion issues with the curved wall because of the overhangs. These settings help minimised it for me.
- Slow down on overhangs should be off
- Using Genetic PETG slow down the max volumetric flow to 10mm/s