1 / 5
Gaggia Classic Manometer/Gauge and Dimmer Housing — zdjęcie 1
1 / 5

Gaggia Classic Manometer/Gauge and Dimmer Housing

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is an alternative gauge and dimmer housing for the Gaggia Classic Pro. It will also work on other machines too.

Ocena
0 / 5
Polubienia
10
Pobrania
68
Wydruki
0
Wyświetlenia
1058
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This housing contains the following components needed to upgrade the Gaggia Classic/Pro. Also it will work with other machines e.g. Rancillio Silvia etc.

1. 40mm Pressure gauge
2. Pump dimmer

There are three 3d parts:

1. The cylindric housing
2. The holder without angle for attaching it flat.
2. The holder with a 20° angle for better readability of the Gauge.

The Holder/s have space for two magnets (12 x 3 mm). I found out that this diameter is strong enaough to hold the housing in place without sliding as you use the Dimmer. You have to print one of the holder and superglue it to the housing. Or just put it in your design-software and combine housing and holder and print it as one part. I Printed it in PETG but as there is no temprature issue you can print it as well in PLA etc. 

Tagi