Neptune4 AntiVibration Feet (slim)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This Version is about 9.5mm high.
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 133
- Wydruki
- 2
- Wyświetlenia
- 845
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
The effectivness can be slightly enhanced by turning 2 of the 4 feet by 90° when placed under the original rubber feet. That way especially the Y-Axis motion is dampened slightly better. This type of design printed in PETg or PLA is still rigid enough to keep a cabinet moving. Only the high pitch resonance frequencies are decoupled from the Surface the printer is on.
i did print it in PETg/colorfabb nGen. 0.5 Layer width which results in exactly 2 lines for the arcs. Infill can be reduced to a minimum. You could even remove top and bottom surfaces if you like the open look