Tina 2 Spool Holder V2.5 Updated
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Full size Spool Holder for the TINA 2.
- Ocena
- 5 / 5
- Polubienia
- 26
- Pobrania
- 498
- Wydruki
- 2
- Wyświetlenia
- 1645
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
V2.5 of the full sized spool holder for the TINA 2 & 2S. Prints in two parts on the TINA 2 & 2S. It's longer and has a slight angle to get the filament path a tad straighter. The treads work, but you have to apply a decent amount of pressure to get them to start. I wanted to see how good the tolerances were so I just ran with the threads Fusion gave me. Well those tolerances are really on point. A chamfer on both would have helped, but I was specifically looking for an answer, and I got it. I'm working on a V3 that will incorporate some bearings to reduce all those pesky frictions. Bring the axil down ~20mm. I'm also thinking a small piece that will hold a piece of PTFE tube to help make the path into the extruder more elegant
Added a spacer to keep the spool from ever touching the Extruder lever. Just remove the spool from holder, slide the spac3er on, put the spool back on.
I've found that you have to cheat models forward and the the right on mine when maxing out the bed, and I have to move the magnet bed back until the front edge of the magnet is flush with the little indention where you would normally grab the magnet to remove.
If you appreciate a tip would always be welcome. You can PayPal me @ paypal.me/CryptoDestro
or even send crypto to
BTC 15gP96C6YkBPdhnUStKVUU1LyjonVnXhe2
Solana 4X1romUPhZHLVhoKrdcJ76NTik9UgmQeEsxxYANYc3Jb
Matic 0x3010FEA7c5A0E7D62740ad742a27cFf14B07387d
Litecoin LPuLQJVvdQRStWUdd2JnkV57BxB4cGiGnh
ETH 0x3010FEA7c5A0E7D62740ad742a27cFf14B07387d