thin rip jig for tablesaw ryobi remix by npopson
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
remixed the carrier to fit ryobi rts12 tablesaw t-track since there isn't really anything out there for it.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 452
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
remixed carrier part to fit Ryobi T-track(miter slot) table saw.
remixed part requires supports so make sure supports(use supports everywhere option) for whatever slicer you are using are dialed in to avoid supports fusing to the narrow gap from the base of part to top of track.
HARDWARE: (everything except bearing was purchased at ace hardware.
-M5 x 20 mm countersunk screw (x1)
&nut (x1)
-M3 x10 mm countersunk screws (x2)
-608-2rs bearing (skateboard bearing) can buy off amazon if short on cash go to npopson page to download bearing alternative.
for assembly visit npopson page linked here.