1 / 2
thin rip jig for tablesaw ryobi remix by npopson — image 1
1 / 2

thin rip jig for tablesaw ryobi remix by npopson

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

remixed the carrier to fit ryobi rts12 tablesaw t-track since there isn't really anything out there for it.

Rating
0 / 5
Likes
4
Downloads
37
Makes
0
Views
452
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Noncommercial — Share Alike

remixed carrier part to fit Ryobi T-track(miter slot) table saw. 

remixed part requires supports so make sure supports(use supports everywhere option) for whatever slicer you are using are dialed in to avoid supports fusing to the narrow gap from the base of part to top of track.

HARDWARE: (everything except bearing was purchased at ace hardware.

-M5 x 20 mm countersunk screw (x1)

&nut (x1)

-M3 x10 mm countersunk screws (x2)

-608-2rs bearing (skateboard bearing) can buy off amazon if short on cash go to npopson page to download bearing alternative.

for assembly visit npopson page linked here.