Adapter from filter for Neato Botvac D-1 ... 10 and more to vacuum cleaner
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Clean the filter of your botvac and save money & reduce waste
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 167
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
During operation of the botvac, dust accumulates in the filter and ultimately blocks the air flow. The filter is waste and must be replaced. Using the adapter and a hoover, the dust can be sucked out of the filter, thus extending its service life.
To clean the filter, proceed as follows:
- connect the filter to the hoover. There are connectors for 32 mm and 35 mm tubes
- insert the filter into the adapter and activate the hoover for about one minute. Meanwhile, gently tap the area around the filter to loosen any stuck dust
- wrap the filter in a damp sponge cloth and tap it a few times on a table top
If there is a significant amount of dust in the sponge cloth, repeat the last two steps
Printer settings:
PLA
infill: 15%
layer height 0.2 or 0.3 mm
brim
support everywhere