Adapter from filter for Neato Botvac D-1 ... 10 and more to vacuum cleaner
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Clean the filter of your botvac and save money & reduce waste
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 23
- Makes
- 0
- Views
- 167
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial
During operation of the botvac, dust accumulates in the filter and ultimately blocks the air flow. The filter is waste and must be replaced. Using the adapter and a hoover, the dust can be sucked out of the filter, thus extending its service life.
To clean the filter, proceed as follows:
- connect the filter to the hoover. There are connectors for 32 mm and 35 mm tubes
- insert the filter into the adapter and activate the hoover for about one minute. Meanwhile, gently tap the area around the filter to loosen any stuck dust
- wrap the filter in a damp sponge cloth and tap it a few times on a table top
If there is a significant amount of dust in the sponge cloth, repeat the last two steps
Printer settings:
PLA
infill: 15%
layer height 0.2 or 0.3 mm
brim
support everywhere