Desktop Synth Stand at 40 degrees, for Deluge, Elektron, etc
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple 40 degree synth stand for desktop synths like the Synthstrom Deluge, Elektron Digitakt, etc
- Ocena
- 5 / 5
- Polubienia
- 42
- Pobrania
- 609
- Wydruki
- 3
- Wyświetlenia
- 2464
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Share Alike
Most all the synth stand models I've seen are fairly low incline (20º-30º). I wanted something closer to 45 degrees. This stand is at a 40º incline. It's very much a "v1.0" design but it's been working well for me these last few days.
The stand is designed around a synth with a depth x width around 200 mm x 250 mm (8"x10") but can work for synths bigger or smaller. That width is defined by the 125mm (6") horizontal brace, which can be scaled in the slicer to be longer or shorter to fit your synth.
To print, make two copies of the “synth_stand_side.stl” and one copy of “synth_stand_brace.stl". You can fit all three on a Prusa bed. I used PLA with 0.3mm layer height at 15% infill.
To assemble, the brace friction-fits into the sides. I used a mallet to really seat the brace. You could also then dab some superglue to be really secure.
Fusion360 files included if you want to change some of the parameters or improve upon it.