Sanding Block for 457mm sanding belts (18in)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Sanding Block that use 75 x 457 mm abrasive belt (3 X 18 inches)
- Ocena
- 4 / 5
- Polubienia
- 33
- Pobrania
- 154
- Wydruki
- 1
- Wyświetlenia
- 1137
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A Sanding Block that use 75 x 457 mm abrasive belt (3 X 18 inches)
Print the following 5 parts : Body-A, Body-B, Lever, Pin, Spacer+0
This Sanding Block will accommodate most 75 x 457 mm abrasive belt (3 X 18 inches). You may need to print an alternate spacer to perfectly fit your brand of sanding belt.
This model print without support as there is virtually no overhang.
Fit ans clearances: The pin is intentionally loose, it will be retained by the abrasive belt when in place. The adjusting spacers should hold by friction in the B-part. An ejection hole is in place to remove the adjusting spacers if required. The A and B parts are tight but should slide without effort. A well calibrated printer should have no problem. If you have difficulties, you can print an alternate B part that is looser in the optional folder.
65 x 410mm remix : https://www.printables.com/model/1285164-schleifblock-65-x-410mm
This model is free. If you wish to tip me or support me, you can do so at this link: https://www.printables.com/model/773888-infinity-calander
Please leave comments and suggestions, I do actively maintain this model.