1 / 2
Spill-proof solder tip holder
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Spill-proof solder tip holder
- Ocena
- 0 / 5
- Polubienia
- 19
- Pobrania
- 61
- Wydruki
- 0
- Wyświetlenia
- 364
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- GNU General Public License v2.0
SzczegółyPliki (7)Wydruki i komentarze (Wydruki: 0) (Komentarze: 1)Remiksy (0)Kolekcje (25)Powiązane
I didn't like the existing models, because if you accidentally tip them over, the tips go everywhere. So I created this spill-proof holder.
Following versions are available:
- Normal
- Gridfinity
- Screw mount for YIHUA soldering stations
- Mount it on the opposite side to your hot air gun holder. There should be extra screw holes.
- Magnet
- Put 6x2 size magnets down the channels. To remove, insert a pin in the hole below.
- You could instead just use the gridfinity version sideways. Remember, it's spill-proof.
Note
There's a test print to check the clamping force. You want it a bit tight, since PLA will loosen slightly in a couple days. However, even after months of usage, it doesn't loosen further.
If you want looser/tighter versions, let me know in the comments.
Print settings
No supports. Tested with 0.4 and 0.6 nozzles.