1 / 2
Spill-proof solder tip holder — image 1
1 / 2

Spill-proof solder tip holder

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Spill-proof solder tip holder

Rating
0 / 5
Likes
19
Downloads
61
Makes
0
Views
364
Reviews
0

Updated at source:

Model information

Category
Electronics
License
GNU General Public License v2.0

I didn't like the existing models, because if you accidentally tip them over, the tips go everywhere. So I created this spill-proof holder.

Following versions are available:

  1. Normal
  2. Gridfinity
  3. Screw mount for YIHUA soldering stations
    • Mount it on the opposite side to your hot air gun holder. There should be extra screw holes.
  4. Magnet
    • Put 6x2 size magnets down the channels. To remove, insert a pin in the hole below.
    • You could instead just use the gridfinity version sideways. Remember, it's spill-proof.

Note

There's a test print to check the clamping force. You want it a bit tight, since PLA will loosen slightly in a couple days. However, even after months of usage, it doesn't loosen further.

If you want looser/tighter versions, let me know in the comments.

Print settings

No supports. Tested with 0.4 and 0.6 nozzles.

Tags