27 Minute Wham-Bam Thank You Ma'am Flat-pack iPhone Stand Portrait
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Orientacyjna cena wydruku pliku
0,37 € – 0,45 € netto (bez VAT)
Dla pliku: Flat-pack Phone stand portrait_0.2mm_PLA_MK3S_27m.gcode
To wstępna wycena jednego pliku. Dokładną cenę poznasz przed zamówieniem.
Plik i założenia wyceny
Plik użyty do wyceny
Średnia wycena orientacyjna: 0,41 € netto (środek widełek).
- Masa podana przez autora
- 4 g
- Czas druku podany przez autora
- 27,6 min
- Materiał u źródła
- PLA
- Materiał wyceny
- PLA
- Drukarka wyceny
- Bambu Lab P1S - 0.4 nozzle
- Proces wyceny
- 0.20mm Standard
Orientacyjna wycena wyłącznie wybranego pliku, oparta na masie i czasie druku podanych przez autora. Warianty plików nie są sumowane. Ostateczna cena zostanie obliczona po analizie pliku.
Zapisane na tym urządzeniu.
This is an iPhone stand that prints flat on the build plate. This holds the phone for portrait viewing.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 43
- Wydruki
- 1
- Wyświetlenia
- 260
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution
This is an iPhone stand designed to print flat on the build plate in multiple pieces that snap together. Goals were to print fast, use a minimum amount of filament, and to pack into a very small space. Although tested with iPhones, this will likely work well with other phones.
This has been printed with PLA but would also work well with PETG. The files included are sized for a typical phone, but could be scaled up for use with a tablet.
Printed at 0.3mm, this will complete in 27 minutes on an Prusa MK3.
This was designed to hold the phone in portrait orientation, but will work in landscape. I also have a landscape-only version that is smaller and will print in less than 15 minutes.