1 / 3
AirTag clip for Peak Design Anchor Link System
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Compatible with (I think) all products using V4 Anchor Link System from Peak Design
- Ocena
- 5 / 5
- Polubienia
- 35
- Pobrania
- 153
- Wydruki
- 1
- Wyświetlenia
- 1634
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 1) (Komentarze: 4)Remiksy (1)Kolekcje (59)Powiązane
Files
- peakDesignAirTagV2 [2024-02-01] - Recommended! Minor alterations to geometry around AirTag to allow easier insertion/removal. Still a very secure hold!
- peakDesignAirTag [2024-01-29]: Original file (shown in video). AirTag is difficult to insert and even more difficult to remove
Printing
Requires supports! I suggest 0.1mm layer height and PETG (or other robust material) for aesthetics and durability, respectively. It is fully functional at 0.2mm in PLA and PETG.
[Printables | Makerworld ]
Instructions
Thoroughly remove support material. The tolerances are tight and small remnants can interfere with the function of the clip. AirTag insertion requires quite a bit of force!
Notes
- Designed to allow full functionality of the PD Anchor Link System
- Tested on Cuff and the Anchors Links included with Everyday Backpack Zip
- Should work (but untested) with Leash & Slide camera straps, but NOT with Slide Lite as it has a wider base. I will consider supporting Slide Lite if there's interest!