Extra mudgard for Seaside Signature cargobike
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An extra "flap" to protect you from small droplets of water hurdeling against you (from the wheels) while biking.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 86
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Public Domain
I have a Seaside "Signature" Bike, that covers my arms and sides with small specs of dirt whenever there is rain or enough water on the ground that the wheels hurdle water towards me. So i made these mudflaps or extensions that you can clip on to the fender mount.
I have printed these in both PLA and PETG but will eventually try to print it in ASA.
A fair Warning. This is my first time designing anything in CAD. And therefore there is probably a lot of stupid decisions made.
I have printed these flaps with my new sovol sv06plus and the prints faild on me twice because one side lifted up slightly from the bed and the nozel pushed the print of the bed. This would most likely be solved if printed with some extra bedadhesion or if the design was a little bitt better. I made a littel “lip” that extrudes under the print that would “snap on” or keep the flap in place and dont fall of in case there would be lots of vibration. witch in hindsight probably made the file a bitt tricky to print.