Levo G2 - Clamps for Surface Go/Surface w Pen Attachment
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Clamps for the Levo G2 Deluxe Tablet Stand. Magnetic pen clamp and clamp with Surface Go cutouts.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 247
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The Levo G2 is a pretty great tablet stand. But on my Surface Go 2, the side clamps cover the magnetic pen attachment points on one side and the charge port on the other side. So I made these replacements. If you use them, please don't hang the tablet over your head. They haven't been tested for that.
In addition to the Surface Go clamps, there are also wider clamps to use with various Surface models. And clamps without a lip at all similar to the ones included with the Levo G2. This was designed for 6x3 round neodymium magnets.
You will have to use supports to print this. I only used supports under the “lip” section. (see picture) Block supports everywhere else and bridging will cover the rest nicely. You can also try turning it 180 degrees for less supports. But make sure you clean them off well because it's a tight fit on that connection.
You will have to pause the print mid way to insert the magnets. I printed at .2 layer height and the stop point was right before layer 83.
Update:
Added clamps for the Thinkpad X12 Detachable Gen 1