Oneplus Open Phone Holder

NEW! - 2024-08-03

Flat Holder - writing edition.STL

New edition released per request! Has a flat writing pad on the right side of the model for being able to better write and draw on your Open for your hand to rest. Has a flatter profile of 5° and sits closer to the table by a few mm. 
*disclamer: I haven't tried it yet, please be aware of any fit issues with the heights relative to the screen and platform! Let me know of any issues! I will hope to get to printing it sometime soon™

Flat Holder right case only.STL

I've also been using the Open without the front screen case (the left side when opened) and thus the phone doesn't sit quite flat anymore. The original model was fine but the phone could wobble a bit. Hence a new release with a raised left-side that supports the outer screen better when unfolded. 

*disclamer: I haven't tried it yet, please be aware of any fit issues with the heights relative to the screen and platform! Let me know of any issues! I will hope to get to printing it sometime soon™

ABOUT

Angles your Oneplus Open phone in a way that is perfect for using on a table or nightstand without wobbling around on the camera! Easy to put on holder and sits flushly. 

Finger cutouts for picking up the phone easily!

Works presently only for the open with the default phone case. Green version in case that makes a difference. 

PRINTING

Printed in TPU; balance of hardness and rigidity. 

If the holder is slightly too loose/tight, scale it lengthwise by stretching 0.25mm at a time to dial it in perfectly. Slice the model 

OTHER

If other dimensions are desired to be changed, leave a comment or DM! Unable to share source but would freely modify and upload. 

If non-case version is required, I would also try to attempt to modify it.