Pixel Watch 2 & 3 stand & wall mount (2 in 1)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Made this stand for my Pixel Watch 2. It's compatible with the original Google charger, and 3rd party ones.
- Ocena
- 4,857 / 5
- Polubienia
- 52
- Pobrania
- 487
- Wydruki
- 9
- Wyświetlenia
- 2129
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial
I've designed this model sot it would fit both the original Pixel Watch 2 charger from Google, as well as 3rd party ones, some of which have a cable strain relief where the cable exits (and so, a wider diameter).
Setup:
- The charging pad clips in from the back and it has a groove to route and hide the cable.
- You have 3 options for using this stand:
- simply set on a flat surface
- screw mounted on a wall (the screw head needs to be smaller than 8mm in diameter and 3mm in thickness)
- magnetically mounted using 3x 8*3mm cylindrical magnets
Note: the model needs to be mirrored when used vertically, so the cable exits in the right direction. i.e. Not like on the picture below which shows it magnetically mounted.
Printing
I've printed this with supports starting at 40% overhang, on build plate only. I've also added a modifier so the base, and the part where the pad goes are heavier (90% infill vs 15%) and the stand doesn't roll on its side (it still may when empty, but should definitely not when the charger is installed).
