Cupid accessories for moveable figure

This is the ninth themed version of my original moveable figure. This figure reuses a lot of the parts from the original model and just uses the accessories found in this model. When it comes to the accessories you have the choice to use a standard bow and arrow or one that has a heart arrow tip. Both bow and arrow files print flat as two halves and use the pins to align them but will require gluing together. To avoid duplicate models I have only included the different STLs in the individual STLs section. I have included a list of parts that you will need from the original below.

Additional parts needed from the original:

• Arms
• Arm pins
• Body
• Hands
• Head top
• Hips (swivel hips can be used from here too)
• Short legs from here (although the original legs will fit too)

Print instructions:

All files have been printed and tested using various brands and colours of PLA/PLA+ on my Prusa Mk4, Prusa Mk3S with MMU2S and my frankenstein 180x180mm bed slinger with the following settings:

• Nozzle size 0.4mm
• Layer height 0.2mm
• 2 perimeters

I haven't found any other setting to affect the fit and function of the assemblies however for the head it is beneficial to observe where the seam placement will end up in the slice preview, I typically set the seam to rear for the heads. The head to neck fit is dependent on your extrusion multiplier calibration. The default settings for both of my Prusa's provide the desired fit.

Assembly instructions:

Please refer to the assembly instructions in the original model. For assembly of the hat press the hat pin into the hat top and then press the hat trim onto the hat pin. The hat will stay aligned once fitted to the head.